アプリケーションギャラリ

Turbulent flow, SSG-LRR interface is employed to investigate turbulent flow in a straight semicircular duct. The resulting flow pattern is characterized by slow secondary motions in the plane normal to the duct axis. The order of magnitude of velocity of those motions is 1% of the ... 詳細を見る

This tutorial shows how to simulate coupled heat and moisture transport in a wall made of a load bearing and an insulation layer. Moisture and temperature conditions vary with time on both sides of the wall and rain loading is included. The 1D model is a benchmark test defined in ... 詳細を見る

Bearing clearances should be kept minimum to avoid non-synchronous vibration of a rotor. However, a tight clearance reduces the durability of the bearing. This example illustrates modeling of the vibration induced by nonlinear contact for different radial clearances. It is shown that ... 詳細を見る

This model computes the specific acoustic radiation impedance of a very small circular vent in a flanged configuration. The model includes thermoviscous losses. The radiation impedance is fitted using a simple RL circuit which gives a simple lumped representation. The results are used ... 詳細を見る

This model shows that the frequency response, i.e. admittance curve, of the SAW unit cell with IDT is in good agreement with the series resonance & antiresonance frequencies obtained from the eigenfrequency studies in the tutorial Surface Acoustic Wave Velocity Calculations from a ... 詳細を見る

This model demonstrates how to couple the Radiative Beam in Absorbing Media interface to the Radiation in Absorbing-Scattering Media interface. To learn more about this model, see our accompanying blog post “Modeling Absorption and Scattering of Collimated Light”. 詳細を見る

This example exemplifies how to model thermal phase change that is subject to hysteresis. A more detailed description of the phenomenon, and the modeling process, can be seen in the blog post "Thermal Modeling of Phase-Change Materials with Hysteresis" as well as: "How to Use State ... 詳細を見る

A trimmer capacitor has a variable capacitance. One way of obtaining this is to use parallel facing electrodes with a variable overlap area. In this example, the capacitance can be changed by turning one electrode using a screwdriver. Typically a linear angular response is desired. ... 詳細を見る

This is a conceptual model of a microphone placed in an infinite baffle (flush mounted). The purpose is to determine the free-field level correction curve of the setup, which includes the exterior domain, microphone grid, and volume between the grid and the diaphragm. The microphone ... 詳細を見る

In this model, the packing behavior of grains is simulated using three force models: Hertz-MD, Hertz-MD with adhesion, Hertz-MD with adhesion and van der Waals forces. The packing efficiency is calculated to quantify the extent of packing observed. 詳細を見る