アプリケーションギャラリ

This tutorial simulates the turn-off transient (reverse recovery) of a simple PIN diode with an inductive load, loosely based on the book "Fundamentals of Power Semiconductor Devices" by B. J. Baliga (p. 256, 2008 edition). Unlike the book, which assumes an initial constant current ramp ... 詳細を見る

This example illustrates how to model the transport of different contaminants through a ceramic water filter candle with an activated carbon core. These types of water filters can be found in table top gravity filters, as well as attached to the faucet or as part of a larger reverse ... 詳細を見る

This model shows how to simulate carburization and quenching of a steel gear. Diffusion of carbon into the surface of the gear affects the onset of martensitic transformation. Residual stresses are computed, and it is shown that high residual compressive stresses appear at the root of ... 詳細を見る

Real reactors can be modeled as combinations of ideal reactors. In this example the so-called "Dead zone model" is utilized. Two ideal CSTRs with interchange are set up to model the real reactor. One CSTR represents the highly agitated region and the other the less agitated region. For ... 詳細を見る

High-performance liquid chromatography (HPLC) is a common method of separating, identifying, and quantifying each chemical compound in a mixture. HPLC is found in the pharmaceutical, biotech, and food industries. The Liquid Chromatography app simulates the separation of two species ... 詳細を見る

この例では, 水で満たされた貯水池の上に置かれた細い垂直シリンダーを調べます. 空気と水の界面の壁面接着と表面張力により, 水は流路を通って上昇します. 表面張力と壁面接着力は, MEMS デバイスのマイクロ流路を通じて流体を輸送したり, マイクロピペットを使用して少量の流体を測定, 輸送, 配置したりするためによく使用されます. 多孔質媒体を通る多相流や固体壁上の液滴も, 壁面接着力と表面張力が流れのダイナミクスに強く影響する例です. 壁面の接着力を正しくモデル化するには, 境界条件の扱いが重要です. 壁面の速度をゼロに固定すると, ... 詳細を見る

This example models wicking in a porous medium. Wicking is the phenomenon that occurs when a dry porous material is put into contact with a fluid: it will absorb the fluid due to capillary forces. The absorption will continue until an equilibrium is reached where the gravitational forces ... 詳細を見る

DC glow discharges in the low-pressure regime have long been used for gas lasers and fluorescent lamps. DC discharges are attractive to study because the solution is time independent. The 1D and 2D models show how to use the DC Discharge interface to set up an analysis of a positive ... 詳細を見る

Wave heated discharges may be very simple, where a plane wave is guided into a reactor using a waveguide, or very complicated as in the case with ECR (electron cyclotron resonance) reactors. In this example, a wave is launched into reactor and an Argon plasma is created. The wave is ... 詳細を見る

Linear motors are used in many applications in need of translational motion. Typical characteristics of linear motor designs are high precision or quick acceleration. This model investigates a synchronous motor with three-phase winding on the stationary part and permanent magnets on the ... 詳細を見る